感應距離 [mm] 8
接口 M12接插件; 鍍金觸點
電流負載 [mA] 150 / 15 **)
電壓降 [V] < 2.5
Damping frequency (max) [Imp./min] 18000
Environmental conditions
Ambient temperature [° C] -20 ... 50, if
the product is used for explosive areas, the temperature is -20 ... 60 ° C
IIT212愛福門速度監控器性能特點
The sensor head operates according to the inductive proximity switch principle.
工作距離 [mm]? 0...6?
開關點調整?? Teach示教功能
遲滯 [Sp的百分比]? 10
啟動延遲 [s]? 0...15
?反應時間
阻尼頻率 (大值) [Imp./min]?? 18000
?環境條件
環境溫度 [°C]? -20...50, 如果產品用于易爆區域外, 溫度為-20...60°C
傳感器頭根據電感式接近開關原理工作。
傳感器檢測旋轉設備上的金屬物件,并將該信息通過內置估算單元轉換成轉速。
如果設定的轉速被過或不足,那么電子輸出進行開關轉換。
應用范圍?? 估算低于設定值的旋轉和直線運動; 鎖定
開關功能?? 在啟動延遲階段和(f 實際值) > (f 額定值)時,達到開關動作 *
The sensor detects the l s on the rotating device and converts
the information into the speed through the built-in estimation unit.
If the set speed is exceeded or insufficient, then the electronic output is switched.
Application range Estimates of rotation and linear motion below the setpoint;
Switch function reaches the switching action when the start delay phase and (f actual value)> (f rating)
修正系數?? 鋼(St37) = 1 / 不銹鋼約0.7 / 黃銅約0.5 / Al約0.4 / Cu約0.3
?測量/設定范圍
設定范圍 [脈沖/分鐘]? 3...6000
Electrical design DC PNP
Switch output normally open / normally closed optional
? Electrical data
Rated voltage [V] 10 ... 36 DC
Current loss [mA] <15
Product Mark II 3D Ex tc IIIC T80 ° C Dc IP67 U ***)
EMC Electromagnetic compatibility EN 60947-5-2
? Mechanical technical data
Installation is not flush mounted
Housing material Stainless steel (320S31); PBT; TPE-U