When calculating air consumption.
Example 1. The MRB series with a cylinder bore of 10 mm and a
stroke of 100 mm runs a round trip at an air pressure of 0.5 MPa.
0.934 × 100 × 10-3 = 0.093R / round trip (ANR)
Example 2. The MRB series with a cylinder bore of 10 mm and a
供應日本小金井無桿氣缸,KOGANEI無桿氣缸 企業QQ:2880626087 ; 手機;() 郵箱;@163.com ;周彩云 地址:上海市嘉定區江橋嘉涌路99弄6號713室
請使用已除去壓縮空氣中水分、垃圾、氧化油等不純物質的清潔空氣。
2:關于可搬運質量與活塞速度的關系,請參閱第頁上的緩沖能力線圖。
3:( )內為H1潤滑脂規格的使用速度范圍。
計算空氣消耗量時。
例1. 氣缸缸徑10mm、行程100mm的MRB系列在空氣壓力0.5MPa下運行1個往返的情況。
0.934×100×10-3=0.093R/往返(ANR)
例2. 氣缸缸徑10mm、行程100mm的MRB系列在空氣壓力0.5MPa下1分鐘運行10個往返的情況。
0.934×100×10×10-3=0.934R/min(ANR)
帶磁性開關導軌型在出廠時已在滑臺的定位銷孔(φ4)一側裝有磁性開關導軌和磁性開關磁石。
在相反一側安裝磁性開關導軌時,請參閱第頁上的磁性開關導
軌、磁性開關磁石的安裝。
2:出廠時已附帶液壓緩沖器、橡膠擋塊、金屬擋塊。
3:輕負載用為接單生產。
W/F≤10
請在各緩沖能力范圍內使用。
垂直安裝
一般情況下 W/F≤0.2
stroke of 100 mm operates 10 rounds at 1 minute at an air pressure of 0.5 MPa.
0.934 × 100 × 10 × 10-3 = 0.934R / min (ANR)
With the magnetic switch rail type in the factory has been located in the slide pin hole
(φ4) side of the magnetic switch rail and magnetic switch magnet. When
installing the magnetic switch rail on the opposite side, refer to the magnetic switch guide on page
Rail, magnetic switch magnet installation.
2: the factory has been equipped with hydraulic buffer, rubber stop, l stop.
3: light load for the production of orders.
4: The maximum number of hydraulic shock absorbers and rubber stoppers is 2.
計算空氣流量時。(選擇F.R.L.、閥等的情況下。)
例 氣缸缸徑10mm的MRB系列以速度300mm/s、在空氣壓力0.5MPa下運行時。
0.934 ×
4:可在不加油狀態下使用,如需加油,請務必咨詢本公司。請勿使用透平油。
5:將安裝螺栓擰入末端蓋板和底座上的所有安裝孔時,工作臺頂面與主體底面的平行度。與行走平行度不同。
6:安裝株式會社METROL的“觸摸開關CS067A”時,行程調節范圍會變小。
表中數值僅為理論值??赡軙c實際使用時的數值有所差異。因此,實際選擇時,會研究允許負載W與理論推
力D之比(W/F)。請根據MRB系列的安裝方向,將以下數值作為參考。
水平安裝
×300×10-3=0.140R/s(ANR)
(此時每分鐘的流量為0.934×
×300×60×10-3=8.406R/min(ANR)。)
4:液壓緩沖器和橡膠擋塊的數量共多2個。 供應日本小金井無桿氣缸,KOGANEI無桿氣缸