standard temperature ranges in the cases of explosion protected solenoids.
Power Consumption
According to DIN VDE 0580 at coil temperature
過濾,潤滑及工作溫度
通常,氣動系統設計的工作溫度范圍很高,為-20°C到+80°C,
電氣部件如線圈高溫度僅限50°C,但在本目錄中還可以找到一些
* r coil only
Attention!
The conditions imposed on the Ex approvals lead to reduction of the permissible
專門的數據。
關于過濾和露點,可采用下面的數據,在5°C到50°C的環境溫
度下,使用40μm的濾芯和低于環境溫度10°C的露點。 當環境
溫度低于5°C或高于50°C時,使用25或5μm的濾芯,環境低于
5°C時,采用比環境溫度低5°C的露點。
閥與氣缸在裝配時都上過潤滑脂,正常工作時可不再加潤滑
脂,然而使用油霧器會延長產品的使用壽命。
經驗規則:下列幾種工況采用潤滑劑:
當閥的頻率>3Hz
氣缸速度高
環境溫度低于5°C或高于50°C時
或以上三種情況的組合
如果可能的話,定期進行潤滑后再繼續使用,對氣缸可使用微
油霧器,對空氣工具可使用油霧器。
of +20 °C. In operation the power consumption of the solenoid
decreases by approx. 30 %.
Solenoid DC 1 AC 2
Inrush Holding
9101 * 8 W 15 VA 12 VA / 7 W
9151 * 18 W 9 VA 9 VA / 7 W