久久综合无码中文字幕无码_国产精品视频专区免费_色欲精品一区二区入口_国产深夜福利视频在线

銷售油研軸向柱塞泵，價格低YUKEN柱塞泵
　　上海乾拓貿易有限公司
　　企業QQ：2880626087
　　；
　　手機；（）
　　郵箱；@163.com
　??；楊婷玉
　　地址：上海市嘉定區江橋嘉涌路99弄6號713室
　　diametre as that of the specified pipe flange to be used. Make
　　sure that the height of the pump suction port is within one
　　metre (3.3 ft) from the oil level in the reservoir.uld be located lower than the
　　pump position to prevent air in the suction line.
　　Install drain piping according to the chart and ensure that
　　pressure within the pump housing should be maintained at
　　a normal pressure of lesUnder the conditions of pressure 1
　　6 MPa (2320 PSI) and
　　speed 1800 r/min, the volumetric efficiency is over 98%
　　NAS級別10級內的污染程度。
　　吸入口必須至少配備100微米
　?。?50目）水箱式過濾器和返回管路Permissible suction pressure at inlet port of the pump is
　　between -16.7 and +50 kPa (5 in.Hg Vacuum and 7 PSIG).
　　For piping to the suction port, use the pipes of the sames than 0.1 MPa (14.5 PSI) and surge
　　pressure of less than 0.5
　　and the overall efficiency is或R＆O（防銹和氧化抑制劑）型液壓油
　　相當于ISO VG-32或46.的粘度
　　范圍為20至400 mm2 / s（98至1800 SSU）和
　　溫度范圍為0?60°（32?140°F）
　　6. Hints on Piping
　　When using steel pipes for the suction or discharge ports,
　　excessive load from the piping to the pump generates excessive
　　Whenever there is fear of excessive load, please use rubber
　　7. Suction Piping
　　In case the pump is installed above the oil level, the suction
　　piping and suction line filter sho必須滿足上述液壓的使用
　　必須謹慎對待維持控制
　　否則會導致工作油污染
　　故障并縮短了設備的使用壽命。 請保持 MPa (72.5 PSI).
　　Length of piping should be less than 1 m (3.3 ft.), and the
　　pipe end should be submerged in oil.
　　9.Bleeding必須 over 90%.

銷售油研軸向柱塞泵，價格低YUKEN柱塞泵